Author |
Topic: Holy manifold? (Read 608 times) |
|
granorpio
Full Member
1998 Silver Facelift Cosworth
Posts: 589
|
 |
Holy manifold?
« on: Feb 11th, 2005, 12:58am » |
 Quote  Modify
|
Perfect picture
http://www.fordscorpio.co.uk/Engine%20Repairs.htm
Is that one or two holes I can see at the end on the plenium chamber after the IAC 
I think the horizontal one is blocked, not sure now about the top one, though I have seen that it has a thread
Shall have to investigate futher (any ideas ) especially after screwing a bolt into it  after all why should there be a hole in a sealed unit anyhow
I must admit, forgetting the fact that I had only seen it because I cleaned the IAC yet again, I found that the idle did improve considerably more so than after cleaning the IAC previously or maybe it's just that I did a better job this time 
|
|
 IP Logged |
- Mike -
So nearly said "goodbye" but now Scorpio will see another day, alongside the replacement! eek!
|
|
|
scorpio_man
Administrator
Ford Kuga awd
Posts: 5654
|
|
Re: Holy manifold?
« Reply #1 on: Feb 11th, 2005, 7:32am » |
Quote Modify
|
hi there
maybe it's from when it was cast. just screw a rod in to hold it?
|
|
IP Logged |
|
|
|
granorpio
Full Member
1998 Silver Facelift Cosworth
Posts: 589
|
|
Re: Holy manifold?
« Reply #2 on: Feb 11th, 2005, 12:36pm » |
Quote Modify
|
I had actually thought of that, but still you would have thought it would have been blanked off later so as not to draw air in to the system.
|
|
IP Logged |
- Mike -
So nearly said "goodbye" but now Scorpio will see another day, alongside the replacement! eek!
|
|
|
|
Home
Help
Search
Members
Login
Reply
Send Topic
Print